It is used to form reinforced concrete pipes, and can produce various series of pipes such as flat mouth, groove mouth and socket. It consists of main frame, mast, suspension roller, tail shaft, pulley, feeder, motor, electric control cabinet, etc. According to the eccentric force caused by the rotation of the cement pipe mold driven by the cement pipe machine, the concrete is thrown on the inner wall of the cement pipe mold. When the concrete material is filled beyond the running circle, the working shaft uniformly crushes the concrete, and the cement slurry is pressed out of the surface to achieve The density of the concrete drainage pipe and the smooth inner wall of the pipe form a complete pipe body.
1). The production cycle of the suspension roller machine is short and the efficiency is high. Placing concrete directly on the suspension roller machine is easy to form, and it takes only 3-5 minutes to turn the tube quickly.
2). The pipes produced by the suspension roller machine are all dry hard concrete, which saves materials, saves energy and protects the environment.
3). The noise produced by the suspension roller machine is low, about 82 decibels.
4). The suspension roller machine is easy to operate, runs smoothly, has low failure and long life.
1). Before starting, check whether all the transmission connection parts are normal, then remove the positioning pin, pull the movable mast outward and rotate it by 90º, so that the suspension roller shaft comes out of the mast, bracket, and is in a free state. The pipe mold is hoisted by the crane and put into the suspension roller shaft, then the door frame is closed, the suspension roller shaft is supported in the sleeve, the positioning pin is inserted into the positioning hole, and then the cement pipe mold is dropped, so that the inner rings of the retaining rings at both ends of the mold Roll on the suspension shaft, remove the wire rope, remove the traffic, and prepare to drive.
2). Start the speed-regulating motor to make the suspension roller drive the mold to idle. After normal operation, start the conveyor to start feeding material to the hopper, and then feed it into the mold through the conveyor belt. After centrifugal force, roller pressure, and vibration force, The role is to gradually compact the concrete. After the molding, the feeding belt is withdrawn from the mold, and the main motor is turned off.
3). Use the crane to lift the densely formed mold to make the suspension roller shaft and the mold inner wall empty. Open the door frame and drive the mold to slowly remove the mold from the suspension roller shaft. Place it on the maintenance trolley and send it to the kiln for steaming. Maintenance, and finally the movable mast is restored to its original state, completing the entire production process of a single tube.
4.Packing & delivery