This machine is a special welding equipment for making reinforced concrete drainage pipe skeleton. It is suitable for welding sockets, flat mouths and other reinforced skeletons. It is one of the main equipment for producing reinforced concrete drainage pipe. It adopts the push bar method, with automatic diameter reduction function, and the angle of the mouth can be adjusted. The electrical system adopts the most advanced technology such as digital control, synchronous proportional control, full frequency control, etc., which has fully improved the whole machine's handling performance and control accuracy.
1).Save manpower and time
2). The processing is more reliable, and the numerical control mechanized operation is adopted, which can meet the specifications in terms of fineness and is more firm.
3). Save processing costs, because the previous manual operation will cause errors in the solution, and it is inevitable to waste steel bars.
4). Diverse production specifications: meet the production requirements of various types of reinforcing cages, and are not affected by factors such as the main reinforcement and stirrups, and the quantity, form, model, size, length and other factors.
3.Safe operating procedures
1). When changing the specification to adjust the position of the slider, be sure to confirm that the bolts are tightened to prevent the slider from flying out during welding and causing an accident.
2). When the equipment runs abnormally, stop the machine immediately to check the cause of the failure, and restart the welding after the fault is removed. When repairing or adjusting the equipment (including adjusting the position of the travel switch and proximity switch), all power to the equipment should be cut off before adjustment or maintenance can be performed. It is strictly forbidden to make adjustments while the equipment is powered on.
3). Before the equipment is powered on, make sure that all personnel are away from the equipment (including the rib reinforcement system and must not cross the rib) to avoid danger.
4). During the welding process of the roll welding machine, the operator must always pay attention to the operating conditions of the equipment, and must not stay away from the equipment and perform other work.
5.Packing & shipping